Mercury Default Usernames & Passwords
The default credentials needed to login to your Mercury router
Info updated March 20, 2024
The majority of Mercury routers have a default username of admin, a default password of admin, and the default IP address of 192.168.1.1.
These Mercury credentials are needed when doing a login to the Mercury router's web interface to change any settings.
Since some of the models don't follow the standards, you can see those in the table below.
Below the table are also instructions on what to do incase you forget your Mercury router password, need to reset your Mercury router to its factory default password, or the password reset doesn't work.
Tip: Press ctrl+f (or cmd+f on Mac) to quickly search for your model number.Mercury default Password List (Valid March 2024)
| Model | Default Username | Default Password | Default IP address |
|
D12G D12G default factory settings |
admin | admin | 192.168.1.1 |
|
D19G D19G default factory settings |
admin | admin | 192.168.1.1 |
|
MW300R v3.x MW300R v3.x default factory settings |
admin | admin | 192.168.1.1 |
|
MW305R v1.x MW305R v1.x default factory settings |
admin | admin | 192.168.1.1 |
|
MW305R v3.x MW305R v3.x default factory settings |
admin | admin | 192.168.1.1 |
Instructions and common questions
Forgot your Mercury router password?
Have you changed the username and/or password of your Mercury router and forgotten what you changed it to?
Don't worry: all Mercury routers come with a default factory set password that you can revert to by following the instructions below.
Reset Mercury router to default password
If you decide to revert your Mercury router to it's factory defaults, you should do the 30-30-30 reset as follows:
- When your Mercury router is powered on, press and hold the reset button for 30 seconds.
- While still holding the reset button pressed, unplug the power of the router and hold the reset button for another 30 seconds
- While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.
Your Mercury router should now be reset to its brand new factory settings, Check the table to see what those are (Most likely admin/admin).
If the factory reset didn't work, check out the Mercury 30 30 30 factory reset guide .
Important: Remember to change the default username and password to increase the security of your router after the factory reset, as the default passwords are available all over the web (like here).
I still can't access my Mercury router with the default password
Make sure that you have followed the reset instructions correctly as the Mercury routers should always rever to their factory default settings when reset.
Otherwise, there is always the risk that your router is damaged and might need to be repaired or replaced.
