E3200 print

Router info

OpenWrt supported: yes (info)
dd-wrt supported: yes (info)
WiFi: 300mbps (abgn)
ETH-ports (LAN): 4
ETH-speed: Gigabit (10/100/1000)
USB-ports: 1

Hard reset instructions for Linksys E3200

Through the webinterface

  1. Open your browser and navigate to the router interface (check default settings below)
  2. Under the Administration tab you will find a sub-tab called Factory defaults
  3. On the Factory defaults page click the button labeled Restore Factory Defaults

With the reset button

  1. Have your unit powered on
  2. Press and hold the reset button for at least 10 seconds until the power light starts blinking, then release.
  3. When the power light goes solid, unplug the power to the router for 10 seconds
  4. Plug the power back in and start the router
  5. When the power light goes solid again the router is ready to use.

The 30-30-30 reset

If the above instructions don't work you can always try the 30-30-30 reset as follows:
  1. When router is powered on, press the reset button and hold for 30 seconds. (Use a paper clip or something sharp)
  2. While holding the reset button pressed, unplug the power of the router and hold the reset button for 30 seconds
  3. While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.
This process usually works for resetting any router to it's factory setting

Default factory settings

Default Gateway IP: 192.168.1.1
Default admin password: admin
Default subnet mask: 255.255.255.0
Default DNS server: 192.168.1.1

User Manuals for E3200

Name Type Size Date
save User Manual pdf 3.79 MB March 31, 2011
Cookies disclaimer

I agree Our site saves small pieces of text information (cookies) on your device in order to deliver better content and for statistical purposes. You can disable the usage of cookies by changing the settings of your browser. By browsing our website without changing the browser settings you grant us permission to store that information on your device.