router Aterm WR8170N-HP print
The NEC Aterm WR8170N-HP router has 300mbps
WiFi, 4 100mbps ETH-ports and
Aterm WR8170N-HP router specifications (specs)
Cpu: 400 MHz
RAM: 64 MiB
Flash: 4 MiB
Custom firmwares: None
WiFi: 300mbps (bgn)
WiFi bands: n/a
WAN: 1 100mbps port
ETH: 4 100mbps ports
Hard reset instructions for NEC Aterm WR8170N-HP
If your Aterm WR8170N-HP router is not working as it should, dropping connections or not being
responsive, you should first do a reset of the router to see if the problems persist. Other
scenarios where you might want to reset your router is if you've forgotten the password or
misconfigured it and can't get access anymore.
Your can reset your NEC Aterm WR8170N-HP in the following way(s):
The 30-30-30 resetThere are no specific instructions for this model yet, but you can always do the 30-30-30 reset as follows:
- When router is powered on, press the reset button and hold for 30 seconds. (Use a paper clip or something sharp)
- While holding the reset button pressed, unplug the power of the router and hold the reset button for 30 seconds
- While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.
This process usually works for resetting any router to it's factory setting.
Note: It is worth reading more about how to reset routers with the 30 30 30 reset and what the risks and considerations are when resetting your router this way, instead of just rebooting it.
Default factory settings for NEC Aterm WR8170N-HP
If you have performed a reset of your Aterm WR8170N-HP device or not changed the defaults, you should be able to access it with the following settings:
Default Gateway IP: 192.168.0.1 NEC login instructions
Default username: admin NEC router default password list
Default password: blank
Default subnet mask: 255.255.255.0
Default DNS server: 192.168.0.1
Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.