router EX6200 print

Router info

OpenWrt supported: no
dd-wrt supported: no
Cpu: 800 MHz
RAM: 128 MiB
Flash: 8 MiB
WiFi: Gigabit (abgn+ac)
WAN-ports:
WAN-speed: N/A ()
ETH-ports (LAN): 5
ETH-speed: Gigabit (10/100/1000)
USB-ports: 0

Hard reset instructions for Netgear EX6200

If your EX6200 router is not working as it should, dropping connections or not being responsive, you should first do a reset of the router to see if the problems persist. Other scenarios where you might want to reset your router is if you've forgotten the password or misconfigured it and can't get access anymore.
Your can reset your Netgear EX6200 in the following way(s):

With the reset button

  1. Have the router powered on (if just booted wait around one minute for it to load)
  2. With a sharp pen or paper clip, press down the Restore Factory Settings button and hold it for about 7 seconds
  3. When the power light starts to blink you can release the reset button and wait for the router to start up
  4. The power light will be solid (not blinking) once the router is started.

The 30-30-30 reset

If the above instructions don't work you can always try the 30-30-30 reset as follows:
  1. When router is powered on, press the reset button and hold for 30 seconds. (Use a paper clip or something sharp)
  2. While holding the reset button pressed, unplug the power of the router and hold the reset button for 30 seconds
  3. While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.

This process usually works for resetting any router to it's factory setting. If that doesn't work be sure to check out the questions and answers incase someone else has had similar problems resetting their router.
Note: It is worth reading more about how to reset routers with the 30 30 30 reset and what the risks and considerations are when resetting your router this way, instead of just rebooting it.

Default factory settings for Netgear EX6200

If you have performed a reset of your EX6200 device or not changed the defaults, you should be able to access it with the following settings:

Default Network name (SSID): NETGEAR_EXT
Default Gateway IP: 192.168.1.250
Default admin username: admin
Default admin password: password
Default subnet mask: 255.255.255.0
Default DNS server: 192.168.1.250
Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.

User Manuals for EX6200

Do you still have questions concerning the router that you can't find online? You can always try the manuals where most questions should be answered from the manufacturer. Below are the device manuals available for your EX6200.

Name Type Size Date
save User Manual (click to download) pdf 1.26 MB Dec. 3, 2013
save User Manual (click to download) pdf 1.64 MB Jan. 12, 2016