AP-DK03
2.4/5GHz 2x2 Wireless Embedded QCA Reference DK03 Board

The Compex AP-DK03 router has Gigabit WiFi, 5 Gigabit ETH-ports and 0 USB-ports.
It is also known as the Compex 2.4/5GHz 2x2 Wireless Embedded QCA Reference DK03 Board.

Quick links:
Default password/Login


AP-DK03 router specifications (specs)

System specs
CPU: 600 MHz
RAM: 128 MiB
Flash: 16 MiB
Custom firmwares: None
Connectivity
WiFi: Gigabit (abgn+ac)
WiFi bands: n/a
WiFi throughput: n/a
WAN: None
ETH: 5 x Gigabit ports
USB-ports: 0

Hard reset instructions for Compex AP-DK03

If your AP-DK03 router is not working as it should, dropping connections or not being responsive, you should first do a reset of the router to see if the problems persist. Other scenarios where you might want to reset your router is if you've forgotten the password or misconfigured it and can't get access anymore.
Your can reset your Compex AP-DK03 in the following way(s):

The 30-30-30 reset

There are no specific instructions for this model yet, but you can always do the 30-30-30 reset as follows:
  1. When router is powered on, press the reset button and hold for 30 seconds. (Use a paper clip or something sharp)
  2. While holding the reset button pressed, unplug the power of the router and hold the reset button for 30 seconds
  3. While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.

This process usually works for resetting any router to it's factory setting.

Note: It is worth reading more about how to reset routers with the 30 30 30 reset and what the risks and considerations are when resetting your router this way, instead of just rebooting it.


Default factory settings for Compex AP-DK03

If you have performed a reset of your AP-DK03 device or not changed the defaults, you should be able to access it with the following settings:

Default subnet mask: 255.255.255.0

Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.



Report error on page
(If info is incorrect)