X1000
N300 Wireless Router with ADSL2+ Modem

The Linksys X1000 router has 300mbps WiFi, 3 100mbps ETH-ports and 0 USB-ports.
It is also known as the Linksys N300 Wireless Router with ADSL2+ Modem.

Quick links:
Default password/Login
User Manuals


X1000 router specifications (specs)

System specs
CPU: 320 MHz
RAM: 64 MiB
Flash: 8 MiB
Custom firmwares: None
Connectivity
WiFi: 300mbps (bgn)
WiFi bands: 2.4GHz
WiFi throughput: n/a
WAN: 1 x 100mbps port
ETH: 3 x 100mbps ports
USB-ports: 0

Linksys X1000 review (quick overview)

Here is the quick comparison of how the Linksys X1000 compares to other routers on our site:

Average 30/100
Editor 76/100
WiFi 6/100
Hardware 9/100
Current price Find best price

For a full list of routers and how they compare to the X1000, check the Router Buying Guide which will help you buy the most price-competitive router.

Hard reset instructions for Linksys X1000

If your X1000 router is not working as it should, dropping connections or not being responsive, you should first do a reset of the router to see if the problems persist. Other scenarios where you might want to reset your router is if you've forgotten the password or misconfigured it and can't get access anymore.
Your can reset your Linksys X1000 in the following way(s):

Through the web interface

  1. Open your browser and navigate to the router interface (check default settings below)
  2. Under the Administration tab you will find a sub-tab called Factory defaults
  3. On the Factory defaults page click the button labeled Restore Factory Defaults

With the reset button

  1. Have your unit powered on
  2. Press and hold the reset button for at least 10 seconds until the power light starts blinking, then release.
  3. When the power light goes solid, unplug the power to the router for 10 seconds
  4. Plug the power back in and start the router
  5. When the power light goes solid again the router is ready to use.

The 30-30-30 reset

If the above instructions don't work you can always try the 30-30-30 reset as follows:
  1. When router is powered on, press the reset button and hold for 30 seconds. (Use a paper clip or something sharp)
  2. While holding the reset button pressed, unplug the power of the router and hold the reset button for 30 seconds
  3. While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.

This process usually works for resetting any router to it's factory setting. If that doesn't work be sure to check out the questions and answers incase someone else has had similar problems resetting their router.

Note: It is worth reading more about how to reset routers with the 30 30 30 reset and what the risks and considerations are when resetting your router this way, instead of just rebooting it.


Default factory settings for Linksys X1000

If you have performed a reset of your X1000 device or not changed the defaults, you should be able to access it with the following settings:

Default subnet mask: 255.255.255.0

Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.



Report error on page
(If info is incorrect)