EdgeRouter X
Advanced Gigabit Ethernet Router

The Ubiquiti Networks EdgeRouter X router has No WiFi, 4 N/A ETH-ports and 0 USB-ports.
It is also known as the Ubiquiti Networks Advanced Gigabit Ethernet Router.

The EdgeRouter X is featured in our
Best Low-end routers: buying guide

Quick links:
Default password/Login
Login instructions



EdgeRouter X router specifications (specs)

System specs
CPU: 880 MHz
RAM: 256 MiB
Flash: 256 MiB + 2 MiB
Custom firmwares: OpenWrt
Connectivity
WiFi: No ()
WiFi bands: n/a
WiFi throughput: n/a
WAN: 1 x N/A port
ETH: 4 x N/A ports
USB-ports: 0

Hard reset instructions for Ubiquiti Networks EdgeRouter X

If your EdgeRouter X router is not working as it should, dropping connections or not being responsive, you should first do a reset of the router to see if the problems persist. Other scenarios where you might want to reset your router is if you've forgotten the password or misconfigured it and can't get access anymore.
Your can reset your Ubiquiti Networks EdgeRouter X in the following way(s):

The 30-30-30 reset

There are no specific instructions for this model yet, but you can always do the 30-30-30 reset as follows:
  1. When router is powered on, press the reset button and hold for 30 seconds. (Use a paper clip or something sharp)
  2. While holding the reset button pressed, unplug the power of the router and hold the reset button for 30 seconds
  3. While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.

This process usually works for resetting any router to it's factory setting. If that doesn't work be sure to check out the questions and answers incase someone else has had similar problems resetting their router.

Note: It is worth reading more about how to reset routers with the 30 30 30 reset and what the risks and considerations are when resetting your router this way, instead of just rebooting it.


Default factory settings for Ubiquiti Networks EdgeRouter X

If you have performed a reset of your EdgeRouter X device or not changed the defaults, you should be able to access it with the following settings:

Default Gateway IP: 192.168.1.1 Ubiquiti Networks login instructions
Default username: ubnt Ubiquiti Networks router default password list
Default password: ubnt 
Default subnet mask: 255.255.255.0
Default DNS server: 192.168.1.1
Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.

How to login to the EdgeRouter X

To login to the Advanced Gigabit Ethernet Router and change the settings, you can follow these steps:

  1. Make sure you are connected to the router's network, either by Wi-Fi or ethernet cable.
  2. Open your browser and visit http://192.168.1.1
  3. You should be prompted with a login dialogue.
  4. Enter the username: ubnt and the password ubnt
    Note: If you have already changed the password use that instead.
  5. You will now be logged in. If you haven't yet changed the defaul password, we recommend that you change it first thing you do after logging in.

If these instructions don't work for your router, you can always try a factory reset to get the default, or try some other common Ubiquiti Networks credentials, as they can usually be shared across models/variants.




Report error on page
(If info is incorrect)