Cisco Meraki Login Instructions
How To Login to a Cisco Meraki Router And Access The Setup Page
The Cisco Meraki router
web interface is the control panel for your router it's where all the settings are
stored and changed. To make changes to your network you'll need to login to your Cisco Meraki router.
If you want to change any of the following:
- Default network name
- WiFi network name & password
- Username and Password
- DHCP client addresses
- Firewall settings
You'll have to access the web interface to do so.
Accessing the Cisco Meraki web interface is pretty straightforward and all you'll need is:
- Access to the network, Either through LAN-cable or through Wi-Fi
- A web browser, which you have.
Following are the instructions to connect to your Cisco Meraki router's interface for configuration and diagnotstics.
Instructions on how to login to the Cisco Meraki router web interface
Make sure that you are connected to your Cisco Meraki router, either by ethernet cable of over
Note: If you're not connected to the network, you won't be able to reach the interface.
Open your browser and type the router's
IP address into the address
field. The most common IP for Cisco Meraki routers is:
192.168.1.1If that IP address doesn't work, you can search the default Cisco Meraki IP address list for your specific model, and how to figure out your Cisco Meraki router gateway IP address.
- The Cisco Meraki web-interface should open and ask for your username & password. If you're not sure about the username/password you can look at the default Cisco Meraki credentials to see what the defaults are, and how to reset to them.
How to configure your Cisco Meraki router
Once you have logged in to the Cisco Meraki admin interface you should be able to change any settings that are
Be careful when you configure your router so that you don't break the network.
One good tip is to write down your current settings before changing anything so that you can revert it incase of trouble.
What if my Cisco Meraki router or network stops working after the configuration change
In case you by mistake make some change that breaks your Cisco Meraki home network, you can always go back to zero by following the generic 30 30 30 hard reset trick.
This is usually the last resort, and if you still have access to the Cisco Meraki interface you can always login to try and revert the settings first (This of course assumes you wrote down the original value before changing it).