WatchGuard Default IP Address List
Instructions to find your WatchGuard router's IP address
Info updated May 9, 2022
Most WatchGuard routers have a default IP address of 10.0.1.1.
The IP address
is required when accessing the
WatchGuard router's web interface
to configure it.
Since some of the models don't follow the standards, you'll have to check in the table below if the common
default doesn't work.
You can also check the instructions on how to figure out your WatchGuard router ip if you are connected to the router's network.
Our readers have reported that their WatchGuard router's have had the following IPs
(more common higher in list)
To access the web interface you'll also probably need a username and password, if you find your model in the list there's a link to the default settings for that model. Most WatchGuard routers use the same default usernames and passwords so you can also check the Default WatchGuard password list to try with that one.
WatchGuard default IP address List (Valid May 2022)
Model | Default IP | Netmask |
Firebox Edge X20e-W / X20eW Firebox Edge X20e-W / X20eW default username & password |
192.168.111.1 Â Open | 255.255.255.0 |
Firebox SOHO 6 (BF4S16E5W) Firebox SOHO 6 (BF4S16E5W) default username & password |
192.168.111.1 Â Open | 255.255.255.0 |
Firebox T35-W (MS3AE5W) Firebox T35-W (MS3AE5W) default username & password |
10.0.1.1 Â Open | 255.255.255.0 |
Firebox T55-W (MS5AE5W) Firebox T55-W (MS5AE5W) default username & password |
10.0.1.1 Â Open | 255.255.255.0 |
FS2E5W FS2E5W default username & password |
10.0.1.1 Â Open | 255.255.255.0 |
Instructions and common questions
How to find out your WatchGuard router gateway IP
In case you have changed your WatchGuard router's default IP address and can't remember it you can find it
out quite easily by following the instructions below.
(This also works when the router gets it's IP address assigned by DHCP.)
Find WatchGuard router ip on Windows
-
Press Win + r
A run prompt should open -
Type
cmd
into the input and press enter
A command prompt will open -
Type the following into the command prompt:
ipconfig | findstr /i "Gateway"
and click enter. - Your Default gateway, probably something like 192.168.0.1, will show
Find WatchGuard router ip on Linux
- Open a terminal window (Shortcut on some distros: ctrl+alt+t)
-
Type the following:
ip route | grep default
and press enter. - You will be presented with your WatchGuard router's IP address
Find WatchGuard router ip on OSX
-
Open the OSX Terminal: Finder > Applications > Utilities > Terminal
Or you can press cmd+space and type terminal -
Type the following command:
netstat -nr | grep default
and press enter. - Your WatchGuard router default IP will be shown, something like 192.168.0.1