IGNITION Design Labs Login Instructions
How To Login to an IGNITION Design Labs Router And Access The Setup Page

The IGNITION Design Labs router web interface is the control panel for your router it's where all the settings are stored and changed. To make changes to your network you'll need to login to your IGNITION Design Labs router.

Requirements to access the IGNITION Design Labs web interface

Accessing the IGNITION Design Labs web interface is pretty straightforward and all you'll need is:

  • IGNITION Design Labs router
  • Access to the network, Either through LAN-cable or through Wi-Fi
  • A web browser, which you clearly have.

Following are the instructions to connect to your IGNITION Design Labs router's interface for configuration and diagnotstics.

1. Make sure you are connected to your IGNITION Design Labs router

To be able to reach the setup pages of your IGNITION Design Labs router, you'll need to be connected to its network.
So start by connecting to the network, either through WiFi or through ethernet cable.

Tip: If you don't know the WiFi password for your IGNITION Design Labs router, you can always connect to it with an ethernernet cable, which won't require a password.

2. Open your web browser and navigate to 192.168.8.1

Open your browser and type the router's IP address into the address field. The most common IP for IGNITION Design Labs routers is: 192.168.8.1 If that IP address doesn't work, you can search the default IGNITION Design Labs IP address list for your specific model.

Tip: Since you're already connected to your IGNITION Design Labs router, you can also use whatsmyrouterip.com to quickly find the IP. It is the "Router Private IP"-value.
192.168.8.1
Type the IP into the address field and press go

3. Enter the username and password for your IGNITION Design Labs router

In the username and password field, enter your current username and password and press enter / sign in.

Default login credentials for IGNITION Design Labs

If you're not sure about the username/password you can look at the default IGNITION Design Labs credentials to see what the defaults are, and how to reset to them.
- The credentials can also be printed on the label on the back of your router.


That's it! You can now configure anything you want on the device.


How to configure your IGNITION Design Labs router

Once you have logged in to the IGNITION Design Labs admin interface you should be able to change any settings that are available.
Be careful when you configure your router so that you don't break the network.

Tip: write down your current settings before changing anything so that you can revert it incase of trouble.

What if my IGNITION Design Labs router or network stops working after a configuration change

In case you by mistake make some change that breaks your IGNITION Design Labs home network, you can always go back to zero by following the generic 30 30 30 hard reset trick.

This is usually the last resort, and if you still have access to the IGNITION Design Labs interface you can always login to try and revert the settings first (This of course assumes you wrote down the original value before changing it).