BlackArmor NAS 220

The Seagate BlackArmor NAS 220 router has No WiFi, 1 Gigabit ETH-ports and 0 USB-ports.

Quick links:
Default password/Login



BlackArmor NAS 220 router specifications (specs)

System specs
CPU: 800 MHz
RAM: 128 MiB
Flash: 32 MiB
Custom firmwares: None
Connectivity
WiFi: No ()
WiFi bands: n/a
WiFi throughput: n/a
WAN: None
ETH: 1 x Gigabit port
USB-ports: 0

Hard reset instructions for Seagate BlackArmor NAS 220

If your BlackArmor NAS 220 router is not working as it should, dropping connections or not being responsive, you should first do a reset of the router to see if the problems persist. Other scenarios where you might want to reset your router is if you've forgotten the password or misconfigured it and can't get access anymore.
Your can reset your Seagate BlackArmor NAS 220 in the following way(s):

The 30-30-30 reset

There are no specific instructions for this model yet, but you can always do the 30-30-30 reset as follows:
  1. When router is powered on, press the reset button and hold for 30 seconds. (Use a paper clip or something sharp)
  2. While holding the reset button pressed, unplug the power of the router and hold the reset button for 30 seconds
  3. While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.

This process usually works for resetting any router to it's factory setting.

Note: It is worth reading more about how to reset routers with the 30 30 30 reset and what the risks and considerations are when resetting your router this way, instead of just rebooting it.


Default factory settings for Seagate BlackArmor NAS 220

If you have performed a reset of your BlackArmor NAS 220 device or not changed the defaults, you should be able to access it with the following settings:

Default username: admin Seagate router default password list
Default password: adminĀ 
Default subnet mask: 255.255.255.0

Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.

BlackArmor NAS 220 Firmwares

Staying up to date with the latest firmware is a good idea to keep your router even more secure from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider flashing an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly increase the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Seagate BlackArmor NAS 220:

Seagate stock firmware for the BlackArmor NAS 220

Stock firmwares for the BlackArmor NAS 220 are available under the download section on the modem's support page. You can also refer to the router's manual for instructions on how to upgrade the firmware.




Report error on page
(If info is incorrect)