Kyocera Login Instructions
How To Login to a Kyocera Router And Access The Setup Page
The Kyocera router
web interface is the control panel for your router it's where all the settings are
stored and changed. To make changes to your network you'll need to login to your Kyocera router.
Requirements to access the Kyocera web interface
Accessing the Kyocera web interface is pretty straightforward and all you'll need is:
- Kyocera router
- Access to the network, Either through LAN-cable or through Wi-Fi
- A web browser, which you clearly have.
Following are the instructions to connect to your Kyocera router's interface for configuration and diagnotstics.
1. Make sure you are connected to your Kyocera router
To be able to reach the setup pages of your Kyocera router, you'll need to be connected to its network.
So start by connecting to the network, either through WiFi or through ethernet cable.
2. Open your web browser and navigate to 192.168.0.1
Open your browser and type the router's IP address into the address field. The most common IP for Kyocera routers is: 192.168.0.1 If that IP address doesn't work, you can search the default Kyocera IP address list for your specific model.
3. Enter the username and password for your Kyocera router
In the username and password field, enter your current username and password and press enter / sign in.
Default login credentials for KyoceraIf you're not sure about the username/password you can look at the default Kyocera credentials to see what the defaults are, and how to reset to them.
- The credentials can also be printed on the label on the back of your router.
That's it! You can now configure anything you want on the device.
How to configure your Kyocera router
Once you have logged in to the Kyocera admin interface you should be able to change any settings that are
Be careful when you configure your router so that you don't break the network.
What if my Kyocera router or network stops working after a configuration change
In case you by mistake make some change that breaks your Kyocera home network, you can always go back to zero by following the generic 30 30 30 hard reset trick.
This is usually the last resort, and if you still have access to the Kyocera interface you can always login to try and revert the settings first (This of course assumes you wrote down the original value before changing it).