Netcore Default IP Address List
Info updated July 3, 2019
Instructions to find your Netcore router's IP address
Most Netcore routers have a default IP address of 192.168.1.1.
The IP address
is required when accessing the
Netcore router's web interface
to configure it.
Since some of the models don't follow the standards, you'll have to check in the table below if the common default doesn't work.
You can also check the instructions on how to figure out your Netcore router ip if you are connected to the router's network.
Our readers have reported that their Netcore router's have had the following IPs
(more common higher in list)
To access the web interface you'll also probably need a username and password, if you find your model in the list there's a link to the default settings for that model. Most Netcore routers use the same default usernames and passwords so you can also check the Default Netcore password list to try with that one.
Netcore default IP address List (Valid July 2019)
NW502 default username & password
NW616 default username & password
NW702 default username & password
NW705P default username & password
NW725 default username & password
NW725P default username & password
Instructions and common questions
How to find out your Netcore router gateway IP
In case you have changed your Netcore router's default IP address and can't remember it you can find it
out quite easily by following the instructions below.
(This also works when the router gets it's IP address assigned by DHCP.)
Find Netcore router ip on Windows
Press Win + r
A run prompt should open
cmdinto the input and press enter
A command prompt will open
Type the following into the command prompt:
ipconfig | findstr /i "Gateway"and click enter.
- Your Default gateway, probably something like 192.168.0.1, will show
Find Netcore router ip on Linux
- Open a terminal window (Shortcut on some distros: ctrl+alt+t)
Type the following:
ip route | grep defaultand press enter.
- You will be presented with your Netcore router's IP address
Find Netcore router ip on OSX
Open the OSX Terminal: Finder > Applications > Utilities > Terminal
Or you can press cmd+space and type terminal
Type the following command:
netstat -nr | grep defaultand press enter.
- Your Netcore router default IP will be shown, something like 192.168.0.1