DX-E402 v1.0

The Dynex DX-E402 v1.0 router has No WiFi, 4 100mbps ETH-ports and 0 USB-ports.

Quick links:
Default password/Login



DX-E402 v1.0 router specifications (specs)

System specs
CPU: n/a
RAM: n/a
Flash: n/a
Custom firmwares: None
Connectivity
WiFi: No ()
WiFi bands: n/a
WiFi throughput: n/a
WAN: 1 x 100mbps port
ETH: 4 x 100mbps ports
USB-ports: 0

Dynex DX-E402 review (quick overview)

Here is the quick comparison of how the Dynex DX-E402 compares to other routers on our site:

Average 26/100
Editor 76/100
WiFi 2/100
Hardware 1/100
Current price $6.50

For a full list of routers and how they compare to the DX-E402 v1.0, check the Router Buying Guide which will help you buy the most price-competitive router.

Hard reset instructions for Dynex DX-E402 v1.0

If your DX-E402 v1.0 router is not working as it should, dropping connections or not being responsive, you should first do a reset of the router to see if the problems persist. Other scenarios where you might want to reset your router is if you've forgotten the password or misconfigured it and can't get access anymore.
Your can reset your Dynex DX-E402 v1.0 in the following way(s):

The 30-30-30 reset

There are no specific instructions for this model yet, but you can always do the 30-30-30 reset as follows:
  1. When router is powered on, press the reset button and hold for 30 seconds. (Use a paper clip or something sharp)
  2. While holding the reset button pressed, unplug the power of the router and hold the reset button for 30 seconds
  3. While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.

This process usually works for resetting any router to it's factory setting. If that doesn't work be sure to check out the questions and answers incase someone else has had similar problems resetting their router.

Note: It is worth reading more about how to reset routers with the 30 30 30 reset and what the risks and considerations are when resetting your router this way, instead of just rebooting it.


Default factory settings for Dynex DX-E402 v1.0

If you have performed a reset of your DX-E402 v1.0 device or not changed the defaults, you should be able to access it with the following settings:

Default username: admin
Default password: admin 
Default subnet mask: 255.255.255.0

Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.



Report error on page
(If info is incorrect)