NanoPi NEO2

The FriendlyARM NanoPi NEO2 router has No WiFi, 1 Gigabit ETH-ports and 0 USB-ports.

Quick links:
Default password/Login


NanoPi NEO2 router specifications (specs)

System specs
CPU: 816 MHz
RAM: 512 MiB
Flash: n/a
Custom firmwares: None
Connectivity
WiFi: No ()
WiFi bands: n/a
WiFi throughput: n/a
WAN: None
ETH: 1 x Gigabit port
USB-ports: 0

FriendlyARM NanoPi review (quick overview)

Here is the quick comparison of how the FriendlyARM NanoPi compares to other routers on our site:

Average 34/100
Editor 70/100
WiFi 2/100
Hardware 31/100
Current price $118.99

For a full list of routers and how they compare to the NanoPi NEO2, check the Router Buying Guide which will help you buy the most price-competitive router.

Hard reset instructions for FriendlyARM NanoPi NEO2

If your NanoPi NEO2 router is not working as it should, dropping connections or not being responsive, you should first do a reset of the router to see if the problems persist. Other scenarios where you might want to reset your router is if you've forgotten the password or misconfigured it and can't get access anymore.
Your can reset your FriendlyARM NanoPi NEO2 in the following way(s):

The 30-30-30 reset

There are no specific instructions for this model yet, but you can always do the 30-30-30 reset as follows:
  1. When router is powered on, press the reset button and hold for 30 seconds. (Use a paper clip or something sharp)
  2. While holding the reset button pressed, unplug the power of the router and hold the reset button for 30 seconds
  3. While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.

This process usually works for resetting any router to it's factory setting. If that doesn't work be sure to check out the questions and answers incase someone else has had similar problems resetting their router.

Note: It is worth reading more about how to reset routers with the 30 30 30 reset and what the risks and considerations are when resetting your router this way, instead of just rebooting it.


Default factory settings for FriendlyARM NanoPi NEO2

If you have performed a reset of your NanoPi NEO2 device or not changed the defaults, you should be able to access it with the following settings:

Default subnet mask: 255.255.255.0

Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.



Report error on page
(If info is incorrect)