WAP-001 rev. 1 router specifications (specs)
RAM: 32 MiB
Flash: 8 MiB
Custom firmwares: None
WiFi: 300mbps (bgn)
WiFi bands: 2.4GHz
WiFi throughput: n/a
ETH: 1 x 100mbps port
Hard reset instructions for Handlink WAP-001 rev. 1
If your WAP-001 rev. 1 router is not working as it should, dropping connections or not
responsive, you should first do a reset of the router to see if the problems persist. Other
scenarios where you might want to reset your router is if you've forgotten the password or
misconfigured it and can't get access anymore.
Your can reset your Handlink WAP-001 rev. 1 in the following way(s):
The 30-30-30 resetThere are no specific instructions for this model yet, but you can always do the 30-30-30 reset as follows:
- When router is powered on, press the reset button and hold for 30 seconds. (Use a paper clip or something sharp)
- While holding the reset button pressed, unplug the power of the router and hold the reset button for 30 seconds
- While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.
This process usually works for resetting any router to it's factory setting.
Note: It is worth reading more about how to reset routers with the 30 30 30 reset and what the risks and considerations are when resetting your router this way, instead of just rebooting it.
Default factory settings for Handlink WAP-001 rev. 1
If you have performed a reset of your WAP-001 rev. 1 device or not changed the defaults, you should be able to access it with the following settings:
Default Gateway IP: 10.59.1.254 Handlink login instructions
Default username: admin Handlink router default password list
Default password: admin
Default subnet mask: 255.255.255.0
Default DNS server: 10.59.1.254
Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.
How to login to the WAP-001 rev. 1
To login to the In Wall Box Access Point and change the settings, you can follow these steps:
- Make sure you are connected to the router's network, either by Wi-Fi or ethernet cable.
- Open your browser and visit http://10.59.1.254
- You should be prompted with a login dialogue.
Enter the username:
adminand the password
Note: If you have already changed the password use that instead.
- You will now be logged in. If you haven't yet changed the defaul password, we recommend that you change it first thing you do after logging in.
If these instructions don't work for your router, you can always try a factory reset to get the default, or try some other common Handlink credentials, as they can usually be shared across models/variants.
Report error on page
(If info is incorrect)