TI-Navigator Access Point (AP-201A)

The Texas Instruments TI-Navigator Access Point (AP-201A) router has 11mbps WiFi, 1 100mbps ETH-ports and 0 USB-ports.

Quick links:
Default password/Login
User Manuals



TI-Navigator Access Point (AP-201A) router specifications (specs)

System specs
CPU: n/a
RAM: 4 MiB
Flash: 2 MiB
Custom firmwares: None
Connectivity
WiFi: 11mbps (b)
WiFi bands: 2.4GHz
WiFi throughput: n/a
WAN: None
ETH: 1 x 100mbps port
USB-ports: 0

Hard reset instructions for Texas Instruments TI-Navigator Access Point (AP-201A)

If your TI-Navigator Access Point (AP-201A) router is not working as it should, dropping connections or not being responsive, you should first do a reset of the router to see if the problems persist. Other scenarios where you might want to reset your router is if you've forgotten the password or misconfigured it and can't get access anymore.
Your can reset your Texas Instruments TI-Navigator Access Point (AP-201A) in the following way(s):

The 30-30-30 reset

There are no specific instructions for this model yet, but you can always do the 30-30-30 reset as follows:
  1. When router is powered on, press the reset button and hold for 30 seconds. (Use a paper clip or something sharp)
  2. While holding the reset button pressed, unplug the power of the router and hold the reset button for 30 seconds
  3. While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.

This process usually works for resetting any router to it's factory setting.

Note: It is worth reading more about how to reset routers with the 30 30 30 reset and what the risks and considerations are when resetting your router this way, instead of just rebooting it.


Default factory settings for Texas Instruments TI-Navigator Access Point (AP-201A)

If you have performed a reset of your TI-Navigator Access Point (AP-201A) device or not changed the defaults, you should be able to access it with the following settings:

Default subnet mask: 255.255.255.0

Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.



Report error on page
(If info is incorrect)