4ipnet Default Usernames & Passwords
Info updated Dec. 27, 2020
The default credentials needed to login to your 4ipnet router
The majority of 4ipnet routers have a default username of admin, a default password of admin, and the default IP address of 192.168.1.1.
These 4ipnet credentials are needed when doing a
login to the 4ipnet router's web interface
to change any settings.
Since some of the models don't follow the standards, you can see those in the table below.
Below the table are also instructions on what to do incase you forget your 4ipnet router password, need to reset your 4ipnet router to its factory default password, or the password reset doesn't work.Tip: Press ctrl+f (or cmd+f on Mac) to quickly search for your model number.
4ipnet default Password List (Valid December 2020)
|Model||Default Username||Default Password||Default IP address|
EAP110 default factory settings
EAP260 default factory settings
HSG200 default factory settings
OWL550 default factory settings
Instructions and common questions
Forgot your 4ipnet router password?
Have you changed the username and/or password of your 4ipnet router and forgotten what you changed
Don't worry: all 4ipnet routers come with a default factory set password that you can revert to by following the instructions below.
Reset 4ipnet router to default password
If you decide to revert your 4ipnet router to it's factory defaults, you should do the 30-30-30 reset as follows:
- When your 4ipnet router is powered on, press and hold the reset button for 30 seconds.
- While still holding the reset button pressed, unplug the power of the router and hold the reset button for another 30 seconds
- While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.
Your 4ipnet router should now be reset to its brand new factory settings, Check the table to see
what those are (Most likely admin/admin).
If the factory reset didn't work, check out the 4ipnet 30 30 30 factory reset guide .
Important: Remember to change the default username and password to increase the security of your router after the factory reset, as the default passwords are available all over the web (like here).
I still can't access my 4ipnet router with the default password
Make sure that you have followed the reset instructions correctly as the 4ipnet routers should always
rever to their factory default settings when reset.
Otherwise, there is always the risk that your router is damaged and might need to be repaired or replaced.