Belkin Default Password, Login & IP List

Info updated Dec. 16, 2017

The majority of Belkin routers have a default username of -, a default password of -, and the default IP address of 192.168.2.1.

These Belkin credentials are needed when doing a login to the Belkin router's web interface to change any settings.
Since some of the models don't follow the standards, you can see those in the table below.

Below the table are also instructions on what to do incase you forget your Belkin router password, need to reset your Belkin router to its factory default password, or the password reset doesn't work.

Tip: Press ctrl+f (or cmd+f on Mac) to quickly search for your model number.

Belkin default Password List (Valid December 2017)

Model Default Username Default Password Default IP address
BoB (F1PI243EGau, iinet)
BoB (F1PI243EGau, iinet) default factory settings
- admin 10.1.1.1
F5D5230-4
F5D5230-4 default factory settings
Admin - 192.168.2.1
F9K1103 v1
F9K1103 v1 default factory settings
admin password 192.168.2.1
F9K1103 v1xxx
F9K1103 v1xxx default factory settings
admin password 192.168.2.1


Instructions and common questions

Forgot your Belkin router password?

Have you changed the username and/or password of your Belkin router and forgotten what you changed it to?
Don't worry: all Belkin routers come with a default factory set password that you can revert to by following the instructions below.

Reset Belkin router to default password

If you decide to revert your Belkin router to it's factory defaults, you should do the 30-30-30 reset as follows:

  1. When your Belkin router is powered on, press and hold the reset button for 30 seconds.
  2. While still holding the reset button pressed, unplug the power of the router and hold the reset button for another 30 seconds
  3. While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.

Your Belkin router should now be reset to its brand new factory settings, Check the table to see what those are (Most likely None/None).
If the factory reset didn't work, check out the Belkin 30 30 30 factory reset guide .
Important: Remember to change the default username and password to increase the security of your router after the factory reset, as the default passwords are available all over the web (like here).

I still can't access my Belkin router with the default password

Make sure that you have followed the reset instructions correctly as the Belkin routers should always rever to their factory default settings when reset.
Otherwise, there is always the risk that your router is damaged and might need to be repaired or replaced.