AMX Default Usernames & Passwords
Info updated Sept. 1, 2020
The default credentials needed to login to your AMX router
The majority of AMX routers have a default username of Admin, a default password of 1988, and the default IP address of 192.168.1.240.
These AMX credentials are needed when doing a
login to the AMX router's web interface
to change any settings.
Since some of the models don't follow the standards, you can see those in the table below.
Below the table are also instructions on what to do incase you forget your AMX router password, need to reset your AMX router to its factory default password, or the password reset doesn't work.Tip: Press ctrl+f (or cmd+f on Mac) to quickly search for your model number.
AMX default Password List (Valid September 2020)
|Model||Default Username||Default Password||Default IP address|
NXA-WAP200G default factory settings
NXA-WAP250G default factory settings
Instructions and common questions
Forgot your AMX router password?
Have you changed the username and/or password of your AMX router and forgotten what you changed
Don't worry: all AMX routers come with a default factory set password that you can revert to by following the instructions below.
Reset AMX router to default password
If you decide to revert your AMX router to it's factory defaults, you should do the 30-30-30 reset as follows:
- When your AMX router is powered on, press and hold the reset button for 30 seconds.
- While still holding the reset button pressed, unplug the power of the router and hold the reset button for another 30 seconds
- While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.
Your AMX router should now be reset to its brand new factory settings, Check the table to see
what those are (Most likely Admin/1988).
If the factory reset didn't work, check out the AMX 30 30 30 factory reset guide .
Important: Remember to change the default username and password to increase the security of your router after the factory reset, as the default passwords are available all over the web (like here).
I still can't access my AMX router with the default password
Make sure that you have followed the reset instructions correctly as the AMX routers should always
rever to their factory default settings when reset.
Otherwise, there is always the risk that your router is damaged and might need to be repaired or replaced.