Adaptec Default Usernames & Passwords
Info updated June 12, 2019
The default credentials needed to login to your Adaptec router
The majority of Adaptec routers have a default username of admin, a default password of -, and the default IP address of 192.168.8.1.
These Adaptec credentials are needed when doing a
login to the Adaptec router's web interface
to change any settings.
Since some of the models don't follow the standards, you can see those in the table below.
Below the table are also instructions on what to do incase you forget your Adaptec router password, need to reset your Adaptec router to its factory default password, or the password reset doesn't work.Tip: Press ctrl+f (or cmd+f on Mac) to quickly search for your model number.
Adaptec default Password List (Valid June 2019)
|Model||Default Username||Default Password||Default IP address|
AWN-8060 default factory settings
AWN-8084 default factory settings
Instructions and common questions
Forgot your Adaptec router password?
Have you changed the username and/or password of your Adaptec router and forgotten what you changed
Don't worry: all Adaptec routers come with a default factory set password that you can revert to by following the instructions below.
Reset Adaptec router to default password
If you decide to revert your Adaptec router to it's factory defaults, you should do the 30-30-30 reset as follows:
- When your Adaptec router is powered on, press and hold the reset button for 30 seconds.
- While still holding the reset button pressed, unplug the power of the router and hold the reset button for another 30 seconds
- While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.
Your Adaptec router should now be reset to its brand new factory settings, Check the table to see
what those are (Most likely admin/None).
If the factory reset didn't work, check out the Adaptec 30 30 30 factory reset guide .
Important: Remember to change the default username and password to increase the security of your router after the factory reset, as the default passwords are available all over the web (like here).
I still can't access my Adaptec router with the default password
Make sure that you have followed the reset instructions correctly as the Adaptec routers should always
rever to their factory default settings when reset.
Otherwise, there is always the risk that your router is damaged and might need to be repaired or replaced.