Autonet Default Usernames & Passwords
Info updated May 8, 2020
The default credentials needed to login to your Autonet router
The majority of Autonet routers have a default username of -, a default password of -, and the default IP address of 192.168.1.1.
These Autonet credentials are needed when doing a
login to the Autonet router's web interface
to change any settings.
Since some of the models don't follow the standards, you can see those in the table below.
Below the table are also instructions on what to do incase you forget your Autonet router password, need to reset your Autonet router to its factory default password, or the password reset doesn't work.Tip: Press ctrl+f (or cmd+f on Mac) to quickly search for your model number.
Autonet default Password List (Valid May 2020)
|Model||Default Username||Default Password||Default IP address|
Instructions and common questions
Forgot your Autonet router password?
Have you changed the username and/or password of your Autonet router and forgotten what you changed
Don't worry: all Autonet routers come with a default factory set password that you can revert to by following the instructions below.
Reset Autonet router to default password
If you decide to revert your Autonet router to it's factory defaults, you should do the 30-30-30 reset as follows:
- When your Autonet router is powered on, press and hold the reset button for 30 seconds.
- While still holding the reset button pressed, unplug the power of the router and hold the reset button for another 30 seconds
- While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.
Your Autonet router should now be reset to its brand new factory settings, Check the table to see
what those are (Most likely None/None).
If the factory reset didn't work, check out the Autonet 30 30 30 factory reset guide .
Important: Remember to change the default username and password to increase the security of your router after the factory reset, as the default passwords are available all over the web (like here).
I still can't access my Autonet router with the default password
Make sure that you have followed the reset instructions correctly as the Autonet routers should always
rever to their factory default settings when reset.
Otherwise, there is always the risk that your router is damaged and might need to be repaired or replaced.