Bellnet Default Usernames & Passwords
The default credentials needed to login to your Bellnet router

Info updated Sept. 6, 2022

The majority of Bellnet routers have a default username of public, a default password of public, and the default IP address of 172.16.0.1.

These Bellnet credentials are needed when doing a login to the Bellnet router's web interface to change any settings.
Since some of the models don't follow the standards, you can see those in the table below.

Below the table are also instructions on what to do incase you forget your Bellnet router password, need to reset your Bellnet router to its factory default password, or the password reset doesn't work.

Tip: Press ctrl+f (or cmd+f on Mac) to quickly search for your model number.

Bellnet default Password List (Valid September 2022)

Model Default Username Default Password Default IP address
MB7900
MB7900 default factory settings
public public 172.16.0.1


Instructions and common questions

Forgot your Bellnet router password?

Have you changed the username and/or password of your Bellnet router and forgotten what you changed it to?
Don't worry: all Bellnet routers come with a default factory set password that you can revert to by following the instructions below.

Reset Bellnet router to default password

If you decide to revert your Bellnet router to it's factory defaults, you should do the 30-30-30 reset as follows:

  1. When your Bellnet router is powered on, press and hold the reset button for 30 seconds.
  2. While still holding the reset button pressed, unplug the power of the router and hold the reset button for another 30 seconds
  3. While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.

Your Bellnet router should now be reset to its brand new factory settings, Check the table to see what those are (Most likely public/public).
If the factory reset didn't work, check out the Bellnet 30 30 30 factory reset guide .


Important: Remember to change the default username and password to increase the security of your router after the factory reset, as the default passwords are available all over the web (like here).

I still can't access my Bellnet router with the default password

Make sure that you have followed the reset instructions correctly as the Bellnet routers should always rever to their factory default settings when reset.
Otherwise, there is always the risk that your router is damaged and might need to be repaired or replaced.