CastleNet Default Usernames & Passwords
The default credentials needed to login to your CastleNet router

Info updated March 4, 2024

The majority of CastleNet routers have a default username of Admin, a default password of Admin, and the default IP address of 192.168.1.1.

These CastleNet credentials are needed when doing a login to the CastleNet router's web interface to change any settings.
Since some of the models don't follow the standards, you can see those in the table below.

Below the table are also instructions on what to do incase you forget your CastleNet router password, need to reset your CastleNet router to its factory default password, or the password reset doesn't work.

Tip: Press ctrl+f (or cmd+f on Mac) to quickly search for your model number.

CastleNet default Password List (Valid March 2024)

Model Default Username Default Password Default IP address
ARW800
ARW800 default factory settings
Admin Admin 192.168.1.1
ASW600+
ASW600+ default factory settings
Admin Admin 192.168.1.1
ASW800
ASW800 default factory settings
Admin Admin 192.168.1.1
ASW915N+
ASW915N+ default factory settings
admin admin 192.168.1.1
CBV704EW
CBV704EW default factory settings
admin password 192.168.0.1
CBW560
CBW560 default factory settings
cable - 192.168.0.1


Instructions and common questions

Forgot your CastleNet router password?

Have you changed the username and/or password of your CastleNet router and forgotten what you changed it to?
Don't worry: all CastleNet routers come with a default factory set password that you can revert to by following the instructions below.

Reset CastleNet router to default password

If you decide to revert your CastleNet router to it's factory defaults, you should do the 30-30-30 reset as follows:

  1. When your CastleNet router is powered on, press and hold the reset button for 30 seconds.
  2. While still holding the reset button pressed, unplug the power of the router and hold the reset button for another 30 seconds
  3. While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.

Your CastleNet router should now be reset to its brand new factory settings, Check the table to see what those are (Most likely Admin/Admin).
If the factory reset didn't work, check out the CastleNet 30 30 30 factory reset guide .


Important: Remember to change the default username and password to increase the security of your router after the factory reset, as the default passwords are available all over the web (like here).

I still can't access my CastleNet router with the default password

Make sure that you have followed the reset instructions correctly as the CastleNet routers should always rever to their factory default settings when reset.
Otherwise, there is always the risk that your router is damaged and might need to be repaired or replaced.