Gemtek Default Usernames & Passwords
Info updated March 21, 2022
The default credentials needed to login to your Gemtek router
The majority of Gemtek routers have a default username of admin, a default password of admin, and the default IP address of 192.168.0.1.
These Gemtek credentials are needed when doing a
login to the Gemtek router's web interface
to change any settings.
Since some of the models don't follow the standards, you can see those in the table below.
Below the table are also instructions on what to do incase you forget your Gemtek router password, need to reset your Gemtek router to its factory default password, or the password reset doesn't work.Tip: Press ctrl+f (or cmd+f on Mac) to quickly search for your model number.
Gemtek default Password List (Valid March 2022)
|Model||Default Username||Default Password||Default IP address|
P-780 default factory settings
WHRTC-100GW default factory settings
WVRTM-127ACN default factory settings
WX-2211 default factory settings
WX-5803 default factory settings
Instructions and common questions
Forgot your Gemtek router password?
Have you changed the username and/or password of your Gemtek router and forgotten what you changed
Don't worry: all Gemtek routers come with a default factory set password that you can revert to by following the instructions below.
Reset Gemtek router to default password
If you decide to revert your Gemtek router to it's factory defaults, you should do the 30-30-30 reset as follows:
- When your Gemtek router is powered on, press and hold the reset button for 30 seconds.
- While still holding the reset button pressed, unplug the power of the router and hold the reset button for another 30 seconds
- While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.
Your Gemtek router should now be reset to its brand new factory settings, Check the table to see
what those are (Most likely admin/admin).
If the factory reset didn't work, check out the Gemtek 30 30 30 factory reset guide .
Important: Remember to change the default username and password to increase the security of your router after the factory reset, as the default passwords are available all over the web (like here).
I still can't access my Gemtek router with the default password
Make sure that you have followed the reset instructions correctly as the Gemtek routers should always
rever to their factory default settings when reset.
Otherwise, there is always the risk that your router is damaged and might need to be repaired or replaced.