MitraStar Default Usernames & Passwords
The default credentials needed to login to your MitraStar router

Info updated July 7, 2020

The majority of MitraStar routers have a default username of 1234, a default password of -, and the default IP address of 192.168.1.1.

These MitraStar credentials are needed when doing a login to the MitraStar router's web interface to change any settings.
Since some of the models don't follow the standards, you can see those in the table below.

Below the table are also instructions on what to do incase you forget your MitraStar router password, need to reset your MitraStar router to its factory default password, or the password reset doesn't work.

Tip: Press ctrl+f (or cmd+f on Mac) to quickly search for your model number.

MitraStar default Password List (Valid July 2020)

Model Default Username Default Password Default IP address
GPT-2541GNAC
GPT-2541GNAC default factory settings
1234 - 192.168.1.1


Instructions and common questions

Forgot your MitraStar router password?

Have you changed the username and/or password of your MitraStar router and forgotten what you changed it to?
Don't worry: all MitraStar routers come with a default factory set password that you can revert to by following the instructions below.

Reset MitraStar router to default password

If you decide to revert your MitraStar router to it's factory defaults, you should do the 30-30-30 reset as follows:

  1. When your MitraStar router is powered on, press and hold the reset button for 30 seconds.
  2. While still holding the reset button pressed, unplug the power of the router and hold the reset button for another 30 seconds
  3. While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.

Your MitraStar router should now be reset to its brand new factory settings, Check the table to see what those are (Most likely 1234/None).
If the factory reset didn't work, check out the MitraStar 30 30 30 factory reset guide .


Important: Remember to change the default username and password to increase the security of your router after the factory reset, as the default passwords are available all over the web (like here).

I still can't access my MitraStar router with the default password

Make sure that you have followed the reset instructions correctly as the MitraStar routers should always rever to their factory default settings when reset.
Otherwise, there is always the risk that your router is damaged and might need to be repaired or replaced.