Tecom Default Usernames & Passwords
The default credentials needed to login to your Tecom router

Info updated March 10, 2024

The majority of Tecom routers have a default username of admin, a default password of admin, and the default IP address of

These Tecom credentials are needed when doing a login to the Tecom router's web interface to change any settings.
Since some of the models don't follow the standards, you can see those in the table below.

Below the table are also instructions on what to do incase you forget your Tecom router password, need to reset your Tecom router to its factory default password, or the password reset doesn't work.

Tip: Press ctrl+f (or cmd+f on Mac) to quickly search for your model number.

Tecom default Password List (Valid March 2024)

Model Default Username Default Password Default IP address
AW4042U-G default factory settings
admin admin
AW4042U-N default factory settings
admin admin
AW4061 default factory settings
admin system
GR2512 default factory settings
admin admin
GW5051 default factory settings
admin admin
GW6000 default factory settings
admin admin
IG6600 default factory settings
admin1234 123456
WB1000 default factory settings
admin admin
WL5041 default factory settings
- admin

Instructions and common questions

Forgot your Tecom router password?

Have you changed the username and/or password of your Tecom router and forgotten what you changed it to?
Don't worry: all Tecom routers come with a default factory set password that you can revert to by following the instructions below.

Reset Tecom router to default password

If you decide to revert your Tecom router to it's factory defaults, you should do the 30-30-30 reset as follows:

  1. When your Tecom router is powered on, press and hold the reset button for 30 seconds.
  2. While still holding the reset button pressed, unplug the power of the router and hold the reset button for another 30 seconds
  3. While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.

Your Tecom router should now be reset to its brand new factory settings, Check the table to see what those are (Most likely admin/admin).
If the factory reset didn't work, check out the Tecom 30 30 30 factory reset guide .

Important: Remember to change the default username and password to increase the security of your router after the factory reset, as the default passwords are available all over the web (like here).

I still can't access my Tecom router with the default password

Make sure that you have followed the reset instructions correctly as the Tecom routers should always rever to their factory default settings when reset.
Otherwise, there is always the risk that your router is damaged and might need to be repaired or replaced.