Intel Default Usernames & Passwords
Info updated May 24, 2021
The default credentials needed to login to your Intel router
The majority of Intel routers have a default username of admin, a default password of admin, and the default IP address of 192.0.2.1.
These Intel credentials are needed when doing a
login to the Intel router's web interface
to change any settings.
Since some of the models don't follow the standards, you can see those in the table below.
Below the table are also instructions on what to do incase you forget your Intel router password, need to reset your Intel router to its factory default password, or the password reset doesn't work.Tip: Press ctrl+f (or cmd+f on Mac) to quickly search for your model number.
Intel default Password List (Valid May 2021)
|Model||Default Username||Default Password||Default IP address|
AnyPoint DSL Gateway (Model 4400)
AnyPoint DSL Gateway (Model 4400) default factory settings
AnyPoint Wireless Gateway (Model 1400)
AnyPoint Wireless Gateway (Model 1400) default factory settings
PRO/Wireless 5000 LAN Access Point
PRO/Wireless 5000 LAN Access Point default factory settings
Wireless Gateway II (AP1210)
Wireless Gateway II (AP1210) default factory settings
Wireless Gateway (WLGW2011BAK)
Wireless Gateway (WLGW2011BAK) default factory settings
Instructions and common questions
Forgot your Intel router password?
Have you changed the username and/or password of your Intel router and forgotten what you changed
Don't worry: all Intel routers come with a default factory set password that you can revert to by following the instructions below.
Reset Intel router to default password
If you decide to revert your Intel router to it's factory defaults, you should do the 30-30-30 reset as follows:
- When your Intel router is powered on, press and hold the reset button for 30 seconds.
- While still holding the reset button pressed, unplug the power of the router and hold the reset button for another 30 seconds
- While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.
Your Intel router should now be reset to its brand new factory settings, Check the table to see
what those are (Most likely admin/admin).
If the factory reset didn't work, check out the Intel 30 30 30 factory reset guide .
Important: Remember to change the default username and password to increase the security of your router after the factory reset, as the default passwords are available all over the web (like here).
I still can't access my Intel router with the default password
Make sure that you have followed the reset instructions correctly as the Intel routers should always
rever to their factory default settings when reset.
Otherwise, there is always the risk that your router is damaged and might need to be repaired or replaced.